Replacing the graphics card
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the graphics card with the slot on the chassis.
2 Align and place the graphics card into the slot on system board and press down
rmly until the graphics card snaps into place.
3 Replace the two screws (6-32UNCx3.6) that secure the graphics card to the
chassis.
4 Align the tab on the graphics-card bracket to the slot on the chassis.
5 Align the screw holes on the graphics-card bracket to the screw holes on the
chassis and replace the two screws (6-32UNCx3.6) that secures the graphics-
card bracket to the chassis.
6 Connect the graphics-card cable to the graphics card.
7 Place the computer in an upright position.
Post-requisites
Replace the right-side cover.
71
To Next Page
Loading...
Need help?
General
