To Next Page

To Previous Page

Figure 61. Installing the OCP card filler

Next steps

1. Install the expansion riser 2.

2. Install the expansion card riser 1.

System battery

Replacing system battery

Prerequisites

WARNING:

There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only

with the same or equivalent type recommended by the manufacturer. For more information, see the safety

information that shipped with your system.

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Remove the expansion card riser 1.

NOTE: Locate the battery socket. For more information, see the System board connectors section.

Steps

1. Push the battery holder clip away from the battery.

CAUTION:

To avoid damage to the battery holder clip, ensure that you do not bend the battery holder clip

while installing or removing a battery.

2. Pull the battery out of the battery holder.

NOTE: Ensure that the + side of the battery is facing the battery holder clip.

64 Installing and removing system components

Dell EMC PowerEdge C6525 User Manual

Questions and Answers: