Figure 86. Installing the power interposer board
Next steps
1. Reconnect the power cables to the PIB and route the cables properly to avoid cable damage.
2. Install the air shroud.
3. Replace the PSU.
4. Follow the procedure that is listed in After working inside your system.
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
96
Installing and removing system components
To Next Page
Loading...
Need help?
General