Dell POWERCONNECT 5548P User Manual

Dell PowerConnect 55xx Systems User Guide 593
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Maintenance Projects\Dell
Contax\CxUGSwitching_DHCP.fm
DELL CONFIDENTIAL – PRELIMINARY 9/11/12 - FOR PROOF ONLY
Defining Interface Settings Using CLI Commands
The following table summarizes the CLI commands for defining fields
displayed in the Interface Settings pages.
The following is an example of the CLI commands that enable DHCP Relay
on VLAN 2, assign it an IP address and show the DHCP Relay status:
Interface Settings Parameters CLI Commands
CLI Command Description
ip dhcp relay enable
no ip dhcp relay enable
Enables the DHCP relay features on the
interface (in Interface Configuration
mode).
Use the no form of this command to
disable the DHCP relay agent feature on
the interface.
ip dhcp relay address ip-
address
no ip dhcp relay address
Defines a DHCP servers available for
DHCP relay.
Use the no form of this command to
remove servers from the list.
console(config)# interface vlan 2
console(config-if)# ip dhcp relay enable
console(config)# ip dhcp relay address 176.16.1.1
console> show ip dhcp relay
DHCP relay is Enabled
Option 82 is Disabled
Maximum number of supported VLANs without IP Address is 0
DHCP relay is not configured on any port.
DHCP relay is not configured on any vlan.
No servers configured

Dell POWERCONNECT 5548P Specifications

General

Brand	Dell
Model	POWERCONNECT 5548P
Category	Switch
Language	English