Chapter 10 Digital KeypadME300
10-5
D. Parameter setting
D-1. Unsigned parameter
(Parameter setting range ≥ 0; for example: Pr.01-00)
1. Without using the left shift key: rotate the digital dial to select and adjust the parameters.
2. Using the left shift key: After you press the left shift key, the last digit starts to blink. Press the
left shift key to move the blinking cursor to the digit to adjust, and increase the value by rotating
the digital dial clockwise. The value goes back to 0 after 9. Decrease the value by rotating the
digital dial counter-clockwise. The value goes to 9 after 0.
For example: the default setting for Pr.01-00 is 60.0. Pressing the left shift key causes the
blinking cursor to move one digit to the left:
The upper limit for Pr.01-00 is 599.0. If you set a value greater than 599.0, “Err” appears
after you press the digital dial, and then the keypad shows the upper limit (599.0) for a second
to remind you of the incorrect setting. The setting value remains as the original set value and the
cursor returns to the last digit.
D-2. Signed parameter setting status 1
(Parameter setting range has no or 1 decimal place, the range can be smaller than 0;
for example: Pr.03-03)
1. Without using the left shift key: rotate the digital dial to select and adjust the parameters.
2. Using the left shift key: After pressing the left shift key, the last digit starts to blink. Press the left
shift key to move the blinking cursor to the digit to adjust, and increase the value by rotating the
digital dial clockwise. The value goes back to 0 after 9. Decrease the value by rotating the digital
dial counter-clockwise, and the value goes to 9 after 0.
3. Press the left shift key to shift the blinking cursor one digit to the left. When you shift to the first
digit and press the digital dial, the digit “0” changes to “-” (minus).
4. As for parameters’ settings of 3-digit and one decimal place (Pr.03-03, -100–100%), it only
displays 3 digits on the keypad.
For example: the default setting for Pr.03-03 is 0.0. If the value should be -100, then use the left
shift key to shift the blinking cursor to the hundreds digit. Rotate the digital dial clockwise to 1,
and then press the left shift key to move to the first digit. Rotate the digital dial from “0” to “-“.
To Next Page
Loading...
Need help?
General