ENGLISH
9
Easy Setup and Operation Easy Setup and Operation
ENGLISH
Starting Auto Setup
3
Press the CURSOR
DD
or
HH
button to select “Auto
Setup”, then press the ENTER button.
• The “Auto Setup” screen appears.
1
Press the SETUP button.
• The “System Setup” menu appears.
• Measurement is cancelled if the MASTER VOLUME control knob
is operated while the Auto Setup is performed.
• If the output volume and crossover frequency of your
subwoofer speaker can be changed, then set the volume to
halfway and the crossover filter to maximum or switch off
the low-pass filter.
2 About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to 2 times. During this time,
“Retry1” or “Retry2” is displayed on the screen.
NOTE:
• When measurements have been made using the
measurement microphone, speakers with built-in filters,
such as a subwoofer, might be set to a value that differs
from the physical distance because of the internal electrical
delay.
When “S. Back” is selected, the test tone during Auto
Setup will be output from the surround back speaker.
When “ZONE2” is selected, change the setting to
“ZONE2”. The test tone during Auto Setup is set so that it
will not be output to ZONE2 (Another room).
When “Bi-Amp” is selected, change the setting to “Bi-
Amp”. The test tone during Auto Setup is set so that it will
be output from the Bi-Amp speaker.
2
Press the CURSOR
DD
or
HH
button to select “Auto
Setup/Room EQ”, then press the ENTER button.
• The “Auto Setup/Room EQ” menu appears.
4
Press the CURSOR
DD
or
HH
button to select
“Power Amp Assign”, then press the CURSOR
FF
or
GG
button to select “S. Back”, “ZONE2” or
“Bi-Amp”.
Measurement of each channel is performed as follows:
5
Press the CURSOR
DD
or
HH
button to select
“Start”, then press the CURSOR
FF
button.
• Start the measurements.
1: Only the front speakers (A) are measured, front speakers
(B) are not available. Even if the front speakers (B) are
set, the setting automatically switches to the front
speakers (A) once measurements are completed.
2: The subwoofer speaker is measured twice.
3: When “ZONE2” and “Bi-Amp” are selected, these are
not displayed.
After each channel is measured, “Calculating” appears.
The display switches to the Auto Setup check screen
automatically.
To Next Page
Loading...
Need help?
Audio Specifications
