ENGLISH
PageDefault settingSpeaker Setup
PageDefault settingAuto Setup / Room EQ
54
Advanced Setup – Part 2 Advanced Setup – Part 2
ENGLISH
System setup items and default values (set upon shipment from the factory)
1. Auto Setup / Room EQ
2. Speaker Setup
1
3
Speaker
Config.
Crossover
Frequency
Input the combination of speakers in your system and their
corresponding sizes (SMALL for regular speakers, LARGE
for full-size, full-range) to automatically set the composition
of the signals output from the speakers and the frequency
response.
Sets the frequency (Hz) below which the bass sound of
the various speaker is to be output from the subwoofer.
Front Sp.
Large
Center Sp. Surround Sp. Subwoofer
Small SmallYes
Surround Back
Sp.
Small / 2sp
4
Channel
Level
This adjusts the volume of the signals output from the
speakers and subwoofer for the different channels in order
to obtain optimum effects.
SW Mode
Setup
This selects the subwoofer speaker for playing deep bass
signals.
5
LFE (Normal)
48
2
Delay Time
This parameter is for optimizing the timing with which the
audio signals are produced from the speakers and
subwoofer according to the listening position.
49, 50
50
50
Front
L & R
Center
Surround
L & R
Subwoofer
12 ft 12 ft 10 ft12 ft
Surround Back
L & R
10 ft
49
Front
L
Front
R
Center Surround R Subwoofer
0 dB 0 dB 0 dB 0 dB 0 dB
Surround L
0 dB
Surround
Back R
0 dB
Surround
Back L
0 dB
80 Hz
1 Auto Setup
Set this to switch the surround back
channel’s power amplifier for ZONE2 or Bi-
Amp use .
SURROUND BACK
8~11
Power Amp
Assign.
2
Manual EQ
Setup
This parameter is for optimizing the Room EQ with which
the audio signals are produced from the speakers.
All Channel and Frequency = 0 dB
52
3
Room EQ
Setup
Set the Room EQ setting with “All” or “Assign” for each
surround mode.
All
52, 53
4
Direct Mode
Setup
Set the ON/OFF setting of Room EQ, in the case of the
surround mode is in “Direct” or “Pure Direct”.
OFF
53
To Next Page
Loading...
Need help?
Audio Specifications
