ENGLISH
47
Advanced Setup – Part 1 Advanced Setup – Part 1
ENGLISH
Make this setting to switch the power amplifier for the surround
back channel to ZONE2 or Bi-Amp.
Setting the Power Amp Assign.
1
Press the CURSOR
DD
or
HH
button to select
“Power Amp Assign.” at the “Option Setup”
menu, then press the ENTER button.
• The “Power Amp Assign.” screen appears.
2
Press the CURSOR
FF
or
GG
button to select the
Amp Assign mode according to the speaker
system you want to set up.
3
Press the ENTER button to enter the setting.
• The “Option Setup” menu appears.
MAIN ZONE
Surround back 7.1ch system
ZONE2
5.1ch system
Bi-Amp 5.1ch system
Power Amp
Assign.
ZONE2
–
2ch system
–
PRE-OUT
S.BACK/ZONE
Surround back
ZONE2
–
SPEAKER OUT
The system setup settings can be locked so that they cannot be
changed easily.
Setting the Setup Lock
1
Press the CURSOR
DD
or
HH
button to select
“Setup Lock” at the “Option Setup” menu, then
press the ENTER button.
• The “Setup Lock” screen appears.
2
Press the CURSOR
FF
button to select “ON”, to
lock the system setup settings.
3
Press the ENTER button to finalize the setting
and exit the system setup mode.
• When the setup lock function is activated, the settings listed
below cannot be changed, and “SETUP LOCKED” is displayed
when related buttons are operated.
• System setup settings
• Surround parameter settings
• Tone control settings
• Channel level settings (including test tones)
• To unlock, press the SETUP button again and display the “Setup
Lock” screen, then select “OFF” and press the ENTER button.
• System setup is complete. Once these settings are made,
there is no need to change them unless different AV components
are connected or the speakers are repositioned.
To Next Page
Loading...
Need help?
Audio Specifications
