4
Press the ENTER button to finish surround
parameter mode.
• The equalizer setting of Normal, Flat, and Front can be selected
after performing the Auto Setup.
• When headphone is connected, the Room EQ cannot be used.
2 Operate the Room EQ from the main unit
1
Press the SURROUND PARAMETER button.
• The surround parameter screen is appears.
2
Press the SURROUND PARAMETER button to
select “Room EQ”.
3
Turn the SELECT knob to select the equalizer
setting.
• When making parameter settings, the display will return to the
regular condition several seconds after the last button was
pressed and the setting will be completed.
2 Surround parameters r
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small),
“medium”, “med.l” (medium-large) and “large”. “small”
recreates a small sound field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level
if the sound seems distorted.
DELAY TIME:
The delay time can be set within the range of 0 to 110 ms only
in the matrix mode.
TONE CONTROL:
This can be set individually for each surround mode except
PURE DIRECT and DIRECT.
ROOM EQ:
This sets the frequency response of each speaker.
• OFF:
The Equalizer is not used.
• Normal:
Adjust the frequency response of all speaker suitable for
general surround system.
• Flat:
Adjust the frequency response of all speakers flat.
• Front:
Adjusts the characteristics of each speaker to the
characteristics of the front speakers.
• Manual:
Selects the setting value that was set in the Manual EQ setup.
To Next Page
Loading...
Need help?
Audio Specifications
