Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
ENGLISH
1
Either turn <SOURCE SELECT> or press [TUNER]
(AMP mode) to select “TUNER”.
2
To operate using the main remote control unit, set the
remote control unit to the TUNER ( ) mode.
(vpage 64 “Remote Control Unit Operations”)
3
Press [SEARCH] to select “PTY”.
4
Watching the display, press ui to call out the desired
program type.
5
Press [CHANNEL].
PTY search begins automatically.
b If there is no station broadcasting the designated program type
with the above operation, all the reception bands are searched.
b The station name is displayed on the display after searching
stops.
6
To continue searching, repeat steps 2 to 4.
b If no station broadcasting the designated program type is found
when all the frequencies have been searched, “NO PROGRAMME”
is displayed.
PTY Search
Use this function to find RDS stations broadcasting a
designated program type (PTY).
For a description of each program type, refer to “Program
Type (PTY)”.
1
Either turn <SOURCE SELECT> or press [TUNER]
(AMP mode) to select “TUNER”.
2
To operate using the main remote control unit, set the
remote control unit to the TUNER ( ) mode.
(vpage 64 “Remote Control Unit Operations”)
3
Press [SEARCH] to select “TP”.
4
Press [CHANNEL].
TP search begins automatically.
b If no TP station is found with the above operation, all the reception
bands are searched.
b The station name is displayed on the display after searching
stops.
5
To continue searching, repeat steps 2 to 3.
b If no other TP station is found when all the frequencies have been
searched, “NO PROGRAMME” is displayed.
TP Search
Use this function to find RDS stations broadcasting traffic
programs (TP stations).
To Next Page
Loading...
Need help?
General
