Digi Connect and ConnectPort TS Family web interface Administration
Digi Connect Family and ConnectPort TS Family
112
l Searching for Network: searching for a wireless network or access point for connection.
l Associated with Network: successfully associated with the network w/ the proper
network settings and encryption.
l Authenticated with Network: successfully authenticated a user name and password with
the network when WPA is enabled.
l Joined Ad Hoc Network: successfully connected to and joined an ad-hoc network.
l Started Ad Hoc Network: successfully created, started, and joined an ad-hoc network.
n Network Name: The name of the wireless network to which the Digi device is connected.
n Network ID: The ID of the wireless network to which the Digi device is connected and
communicating.
n Channel: The frequency channel that the wireless LAN radio uses for the Digi device.
n Transmit Rate: The current transmission rate for the wireless LAN radio.
n Signal Strength: The current receive signal strength as reported by the wireless LAN radio.
Ranges are from 0 to 100.
Remote Manager status
Use the Remote Manager status section to view the connection status for the Remote Manager
service.
Diagnostics
Use the ping utility on the Diagnostics page to determine whether the Digi device can access remote
devices over the network. Type the host name of the remote device you want to access, and click
Ping.
Activate the Find Me LED
For Digi Connect ES products, use the Find Me LED to aid in finding a specific Digi device server among
a group of devices. The locator LED is shown on Digi Connect 48 SB and Digi Connect 4/8 SB with
switch.
n Activate: Click this button to activate the Find Me locator LED. The Find Me locator LEDstarts
blinking.
n Stop: Click this button to deactivate the Find Me locator LED. The Find Me locator LEDstops
blinking.
Reboot
Changes to some device settings require saving the changes and rebooting the Digi Connect and
ConnectPort TS Family. Use the Reboot page to reboot the Digi Connect and ConnectPort TS Family.
To reboot a Digi Connect and ConnectPort TS Family from the web interface:
1. Select Administration > Reboot.
2. Click the Reboot button. Wait approximately one minute for the reboot to complete.
To Next Page
Loading...
Need help?
General