Digi Connect and ConnectPort TS Family command-line
interface
Management through the command line
interface
Digi Connect Family and ConnectPort TS Family
119
n UDP statistics. The info udp command displays the following information:
l The number of datagrams received or sent
l The number of bad datagrams received
l The number of received datagrams that were discarded because the specified port was
invalid
n Wireless statistics. The info wlan command displays detailed statistics for wireless devices
that may aid in troubleshooting network communication problems with a wireless network.
newpass
Use the newpass command to issue a new password to a user.
ping
Use the ping command to test whether a host or other device is active and reachable.
reconnect
Use the reconnect command to reestablish a connection opened by a connect, rlogin, or telnet
command. By default, the reconnect command reestablishes the connection to the last active
session.
rlogin
Use the rlogin command to sign in to a remote system.
send
Use the send command to send a telnet control command, such as break, abort output, are you there,
escape, or interrupt process, to the last active telnet session.
send mode
Use the send mode command to configure the telnet control commands. For example, send telnet
control command to last active telnet session or set telnet operating options.
set alarm
Use the set alarm command to display alarm settings, including conditions that trigger alarms, and
how alarms are sent. You can configure alarms to be sent as either an email message, an SNMP trap,
or both. You can configure the alarms as needed.
set autoconnect
Use the set autoconnect command to configure the autoconnection behaviors for serial port
connections.
To Next Page
Loading...
Need help?
General