SNMP device monitoring capabilities Download a Digi MIB
Digi Connect Family and ConnectPort TS Family
128
Download a Digi MIB
To download a Digi MIB:
1. Locate the support page for your product:
2. Under Product Support, click the Utilities tab.
3. Locate the MIB you want to view under General Diagnostics, Utilities, and MIBs.
Supported SNMP traps
You can enable or disable SNMP traps. Supported SNMP traps include:
n Authentication failure
n Login
n Cold start
n Link up
n Alarms issued in the form of SNMP traps
All products support MIBs for serial alarms/login traps/RFC 1215.
Products with the geofencing/GPS feature support MIBs for geofencing.
Products with mobile/cellular capability support MIBs for mobile alarms.
From the web interface, you can enable/disable traps at Configuration > System > SNMP >
Enable Simple Network Management Protocol (SNMP) traps.
You can configure alarms at Configuration > Alarms > Alarm Conditions > Alarm n >
AlarmDestinations > Send SNMP trap to following destination when alarm occurs.
To Next Page
Loading...
Need help?
General