Digi Connect and ConnectPort TS Family web interface Configuration through the web interface
Digi Connect Family and ConnectPort TS Family
53
n MDI: The connection mode for the Ethernet cable.
Auto: Enables Auto-MDIX mode, where the required cable connection type (straight through or
crossover) is automatically detected. The connection is configured appropriately without the
need for crossover cables to interconnect switches or connecting PCs peer-to-peer. When it is
enabled, you can use either type of cable and the interface automatically corrects any incorrect
cabling. For this automatic detection to operate correctly, the “speed” and “duplex” options
must both be set to “auto.”
MDI: The connection is wired as a Media Dependent Interface (MDI), the standard wiring for
end stations.
MDIX: The connection is wired as a Media Dependent Interface with Crossover (MDIX), the
standard wiring for hubs and switches.
TCP keepalive settings
The DHCP server assigns these network settings, unless they are manually set here.
n Idle Timeout: The period of time that a TCP connection has to be idle before a keep-alive is
sent.
n Probe Interval: The time in seconds between each keep-alive probe.
n Probe Count: The number of times TCP probes the connection to determine if it is alive after
the keep-alive option has been activated. The connection is assumed to be lost after sending
this number of keep-alive probes.
WiFi Interface settings
Digi products with Wi-Fi capability display this setting:
n Maximum transmission rate: The maximum transmission rate that the device will use, in
megabits per second. The complete range of transmission rates is available on all devices
except the ConnectPort X2 - XBee® to Wi-Fi model. For that model, the allowed transmission
rates are: 1, 2, 5.5, 11.
Serial ports configuration
Use the Serial Ports Configuration page to establish a port profile for each serial port on the Digi
Connect and ConnectPort TS Family product. The Serial Ports Configuration page includes the
currently selected port profile for the serial port, detailed configuration settings for the serial port,
dependent on the port profile selected, and links to basic and advanced serial settings.
The Serial Port Configuration page includes the Port Settings pane that lists the available ports and
allows you to configure or copy selected ports.
Select Port Profile
The Select Port Profile page appears when you click Change Profile on the Port Profile Settings
pane.
A port profile allows you to easily configure a serial port based on how you intend to use that port. By
selecting one of the pre-defined profiles, the configuration options are focused only on the settings
required for that particular profile.
The Digi Connect and ConnectPort TS Family supports the following port profiles:
To Next Page
Loading...
Need help?
General