General information
The manufacturer accepts no liability for any
consequences resulting from inappropriate,
negligent or incorrect installation or adjustment of
the optional operating parameters of the equipment
or from mismatching the variable speed drive
(Drive) with the motor.
The contents of this User Guide are believed to be
correct at the time of printing. In the interests of a
commitment to a policy of continuous development
and improvement, the manufacturer reserves the
right to change the specification of the product or
its performance, or the contents of the User Guide,
without notice.
All rights reserved. No parts of this User Guide may
be reproduced or transmitted in any form or by any
means, electrical or mechanical including
photocopying, recording or by any information-
storage or retrieval system, without permission in
writing from the publisher.
Important...
Drive software version
This product is supplied with the latest version of
user-interface and machine-control software. If this
product is to be used in a new or existing system
with other DigitAx Drives, there may be some
differences between their software and the
software in this product. These differences may
cause this product to function differently. This may
also apply to Drives returned from a Control
Techniques Service Centre.
If there is any doubt, contact a Control Techniques
Drive Centre.
Use within the European Union, etc
The following information applies where the end use
of the Drive is within the European Union, the
European Economic Area, or other regions which
have implemented Directives of the European
Council or equivalent measures.
The Drive complies with the Low Voltage Directive
73/23/EEC.
The installer is responsible for ensuring that the
equipment into which the Drive is incorporated
complies with all relevant Directives.
The complete equipment into which the Drive is
incorporated must comply with the EMC Directive
89/336/EEC.
If the Drive is incorporated into a machine, the
manufacturer is responsible for ensuring that the
machine complies with the Machinery Directive
98/37/EC. In particular, the electrical equipment
should generally comply with European Harmonised
Standard EN60204-1.
Copyright © January 1999
Control Techniques Drives Ltd
Author: RFD
Issue Code: dgxu4
Issue Date: January 1999
S/W Version: V04.XX.XX
To Next Page
Loading...
Need help?
General
