Digitax DBE600 User Manual

DigitAx User Guide
Issue code: dgxu4
9-1
9 Security
9.1 Setting up a security code
The Drive is supplied with no security set up
(ie. security code = 0). There is no protection
against unauthorized or accidental editing of
parameters. Use the following procedure to set up
a security code:
1. Set b0 to 1
2. Set Pr25 to the required security code number.
(From 0 to 9999)
3. Set b99 to 1 to save the new security code
At this stage, the security code is set but only in the
User’s Table
. To make the new security code active,
remove
AC power for at least 5 seconds.
9.2 Security access
To edit parameters when a security code is in use,
proceed as follows:
1. Set Pr25 to the User Security Code number.
2. Read/Write parameters can now be edited.
9.3 Changing a security code
1. Set Pr25 to the existing User Security Code
number
2. Follow the procedure in Setting up a security
code.

Digitax DBE600 Specifications

General

Brand	Digitax
Model	DBE600
Category	Controller
Language	English