22
SECTION 4 - EFFECTS AND PARAMETERS
About the Effects Library The Effects Library consists of all the effects Modules you can find in
the RP-12. Broken down into individual categories, specific Modules
and their abbreviated library names are as follows:
The analog section of the RP-12 includes the compressor and the dis-
tortion section. These two items are always available in all Programs.
The analog effects and their Parameters are as follows:
Compressor The RP-12’s compressor is a high-quality, low-noise circuit specially
designed for guitars. Compression can be used to increase sustain
and to tighten up guitars, and is particularly useful on clean sounds.
Parameters of the RP-12 compressor are as follows:
Comp On / Bypass........Turns the Module on or off. When Modules are
bypassed their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
Comp Amount ...............Controls the amount of compression applied to
the signal. Higher settings yield a tighter, more
focused sound, while lower settings allow bet-
ter dynamics. Ranges from 0 to 31.
Comp Level...................Sets the output level of the compressor before
feeding to the distortion. Higher settings send
more signal level into the distortion, yielding
extra gain and drive. Varies from 1 to 7.
Distortion The distortion section of the RP-12 is capable of producing three dis-
tinctly different types of distortion. These three solid-state distortion
sounds range from lightly overdriven, to screaming grunge. The
Grunge setting gives you extremely high-gain distortion, free from the
mush and tonal sacrifices typical of other manufacturers’ products.
Dist On / Bypass ...........Turns the Module on or off. When Modules are
turned off, their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
Distortion Type..............Selects the type of distortion to be used in the
To Next Page
Loading...
Need help?
General
