39
forms set 90 degrees out of phase. Chorus Parameters are as follows:
Chorus On / Off.............Turns the Module on or off. When Modules are
turned off, their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
Chorus Level.................Controls the overall level of the chorus.
Variable from 0 to 100.
Chorus Speed ...............Controls the speed of the chorus sweep.
Variable from 0.06 to 16.00 Hz.
Chorus Depth................This Parameter sets the sweep depth (intensi-
ty) of the chorus. Variable from 0.00 to 30.00
milliseconds.
Chorus Delay (#)...........Sets the amount of delay present in the chorus
effect. Varies from 0 to 60.00 milliseconds.
Chorus Waveform .........Controls the LFO waveform pattern of the cho-
rus effect. SINE produces a smooth sine
wave-type chorus with even transitions in and
out of the turnaround points. TRIANGLE is a
linear chorus effect, and ramps the pitch of the
wave up and down with no slowing at turn-
around points. LOGARITHMIC and EXPO-
NENTIAL waveforms are more dramatic in
their effect on the signal (waveform selection
is not available in 4 Phase Chorus , the wave-
form defaults to the sine form).
Flangers The RP-12 also offers studio-quiet flanging. The dual flange Module
offers exceptionally rich flanging using multiple voices with different
phasing characteristics. The dual flange Module uses two flangers set
180 degrees out of phase. Flange Parameters are as follows:
Flange On / Off .............Turns the Module either on or off. When
Modules are turned off, their Parameters dis-
appear from the Parameter menu. To see the
Parameters, you must turn the Module on.
To Next Page
Loading...
Need help?
General
