52
• Press Function button <MIX ™>. The display reads:
• Move the pedal to its full forward (toe down) position, and press
Function button <MOD ¡>. The display reads:
• Move the pedal to its full back (toe up) position, and press
Function button <MIX ™>. When the display returns to the Utility
setup menu, you have successfully calibrated the CC pedal.
PrgList Assign This section explains the procedure of how to assign a List Size and
assigning Program numbers to step numbers of the List.
• From Program mode, press the <UTILITY> button once.
• Press the Function button <MOD ¡> once. The display reads:
• Press Function button <MORE £>. The display reads:
•Press the <UP> and <DOWN> Parameter buttons to select the list
size you want. The list is set to be 10 steps long from the factory.
However, you can assign up to 32 steps in a list.
•From the above screen press the <RIGHT> Parameter button.
The display reads:
The cursor should be under the Step number on the above screen. At
this point, each time you press the <UP> and <DOWN> Parameter
¡Step Number 1
≤™[PROG NAME] #
List Size:10
≥
¡Pedals ™CC Ped
£PrgList Assign≥
Set Pedal Up
(Back), press ™
Set Pedal Down
(Forward) press¡
¡Assign CC Pedal
™Calibrate Pedal
Section 6 - Pedalboard Set-Up
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
