53
buttons, you will scroll through the number of steps that you assigned
from the above List Size. For example: if you assigned your List Size
to be 6 steps, you will have 6 assignments available.
You may have noticed, as you increment and decrement the Step
Number, the Program Name and number change with the step num-
ber. If you want to change the Program number assigned to the step,
Press Function button <MIX ™>. The cursor should move under the
Program number. The Step Number will remain stationary while you
increment and decrement through the 256 available Programs, using
the Parameter <UP> and <DOWN> buttons.
LED Assign This function gives you the option of choosing how the pedal’s LEDs
will illuminate. There are three options available: Normal, Reversed,
and All on. Normal illuminates the LEDs of the Pedals in use.
Reversed illuminates the LEDs of the Pedals that are not in use. All
On, illuminates all the LEDs.
• From Program mode, press the <UTILITY> button once.
• Press the Function button <MOD ¡> once. The display reads:
• Press the <RIGHT> Parameter button. The display reads:
• Press Function button <MOD ¡> until the desired mode is dis-
played. There are three modes: Normal, All On, and All Off.
Naming Banks This function gives you the option of customizing banks within the RP-
12 by assigning each bank it’s own unique name. This can be a invalu-
able feature when a diverse menu of banks is required. The procedure
for naming banks is as follows:
• From Program mode, press the <UTILITY> button once.
• Press the Function button <MOD ¡> once. The display reads:
• Press the <RIGHT> Parameter button. The display reads:
¡Pedals ™CC Ped
£PrgList Assign≥
¡LEDs:Normal
≤™Bank Names
¡Pedals ™CC Ped
£PrgList Assign≥
Section 6 - Pedalboard Set-Up
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
