47
The Pedalboard functions that affect the processor directly include:
Program changes, Program Up/Down, List Up/Down, Bank
Up/Down/Tuning, and Bypass. The Pedalboard functions that interact
with MIDI and then affect the processor include: Toggle CC and CC
Pedal. The CC Pedal channel and Toggle CC channel allow MIDI CC
information to be sent out the MIDI port allowing for control of the RP-
12, external units, or both together. For more information on how to set
up these functions, see page 51.
The MIDI functions can be broken down into two sections: MIDI
Out/Thru and MIDI In. The MIDI Out/Thru functions include: Program
Send: On/Off, Program Send Map, Device Channel and any MIDI
Merge material if that feature is activated. The MIDI In includes: Any
MIDI data received by the RP-12, MIDI Receive Channel, Program
Receive Map. For more information on how to set up these functions,
see page 58.
Pedalboard Functions Pedals assigned with Program changes allows any Pedal in any Bank
of the RP-12 pedalboard to recall an RP-12 Program number. For
more information on how to assign Program changes to pedals, see
page 51.
Bank Up/Bypass Bank Down/Tuner perform exactly as the name
implies in that they increment and decrement through Banks and
Bypass or put the RP-12 in Tuner Mode For more information on how
to set up these functions, see page 51.
NOTE: When using Program Up/Down or Bank Up/ Down, it is
important to remember that they function only within their assigned
Bank. When you leave the Bank in which they are assigned, they
will take on their assigned function for newly selected Banks.
These functions can be assigned to as many Banks in the RP-12
as you want, but remember that you must set up each Bank indi-
vidually.
List Up, List Down is another useful pedalboard function that allows
you to scroll through a custom sequence of Programs using a single
pedal. This sequence is called a List, and can be defined by the user
(see pg 52). It can be up to 32 steps in length, and each step has its
own Program number assignment. To use the List, assign a Pedal as
List Up and another as List Down.
Toggle CC allows you to set up a Pedal to act as a Continuous
Controller which toggles between values 0 and 127. You will find, for
example, that Pedal 6 in every Bank is assigned as Toggle CC 21 at
the factory. Each time footswitch 6 is pressed, it will toggle between
values 0 and 127 of CC 21. By following the factory default Pedal/CC
map this causes the Distortion to be turned On and Off since it is
linked to CC 21 in all of the Factory Programs. To assign toggle CCs,
see page 51.
Section 5 - RP-12 Functions
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
