To Next Page

To Previous Page

RP360 / RP360 XP

Storing/Copying/Naming Presets

The STORE button is used to store edits made

to a preset’s parameters� The STORE button’s

LED will light whenever a preset’s parameters

have been modiﬁed from their stored value� Any

parameter edits must be stored to a preset before

the processor is powered down or the preset is

changed in order for edits to be retained� Preset

edits can only be stored to a user preset

Plexi-Drive 1

LOOPER READY

1 lexi-Drive P

Plexi-Dri1 :

BACK TO CANCEL

STORE TO:

LETTER DEL/INS

memory location since factory presets cannot be overwritten� The RP360 and RP360XP have 99 user

preset memory locations� Factory presets can be edited and then stored to a user preset location�

When storing a preset you will have the option to change the preset’s name�

To store/copy/rename a preset:

1�

Press the STORE button to initiate the store procedure�

2� If you do not want to change the name of the preset, go to step 3� To modify or change the

name, use the 3

EDIT knobs� Turning the EDIT 1 (LETTER) knob will edit the selected on-

screen character� Turning the

EDIT 2 (CURSOR) knob selects the character you want to edit�

Turning the

EDIT 3 (DEL/INS) knob clockwise will insert space to the left of the selected

character; turning it counter-clockwise will delete characters to the left of the selected

character� The preset name can contain up to 16 characters�

3� If you do not want to change the preset location go to step 4� To select a new preset location,

turn the

SELECT knob until the desired user preset memory location is displayed below the

name�

4� Press the STORE button a second time, or press the SELECT button, to conﬁrm the store

procedure� The LCD display will brieﬂy display “Storing��” then the preset will be stored�

NOTE: Pressing the BACK button at any time during the above store procedure will abort the

procedure�

DigiTech RP360 XP User Manual

Other manuals for DigiTech RP360 XP