DigiTech RP360 XP User Manual

32
RP360 / RP360 XP
Aux Input
The AUX IN connector is used to connect a portable music player or other line-level music playback
device to the RP and jam along with your favorite music� The signal from your playback device will
not pass through any effects and will be output through the RP’s LEFT OUT, RIGHT OUT, and
HEADPHONE connectors�
To use the AUX IN connector:
1�
Connect the headphone output of your music playback device to the AUX IN connector on
the rear panel of the RP using an 1/8” stereo cable as shown below�
2� Press play on your music playback device�
3� Adjust your music playback device’s volume control and the RP’s Master Level control to
achieve the desired mix balance� See Preset Level & Master Level on page 25 for
information on adjusting the RP’s MASTER LEVEL control�
1/8” Stereo Cable
1/8” Stereo Cable
Ground
Left +
Right +
Left
Channel (+)
Right
Channel (+)
Ground
Left
Channel (+)
Right
Channel (+)
Ground

DigiTech RP360 XP Specifications

General

Brand	DigiTech
Model	RP360 XP
Category	Music Pedal
Language	English