To Next Page

To Previous Page

RP360 / RP360 XP

Tap Tempo

Tap Tempo lets you adjust the delay time during performance by tapping a footswitch in time with the

music�

NOTE: You must conﬁgure the RP for Stomp Mode operation, have a Delay effect in the loaded

preset, and have the Delay effect assigned to a footswitch to use the Tap Tempo feature�

To use Tap Tempo:

1�

Conﬁgure the RP for STOMP MODE operation in the System Settings menu� See Footswitch

Modes on page 41 for information on conﬁguring the RP for Stomp Mode operation�

2� Load a preset which has an active Delay effect or add a Delay effect to your preset of choice�

Most presets will have a Delay effect already inserted in the effects chain� For information on

adding and editing effects, see Working With Effects on page 19�

3� Assign the Delay effect to one of the 3 footswitches� The footswitch assigned to the Delay

will be the one used for Tap Tempo� Most presets in the RP will already have the Delay effect

assigned to one of the three footswitches� See Assigning Effects To Footswitches (Stomp

Mode Only) on page 24 for information on how to assign the Delay effect to a footswitch�

4� From the Performance state, press and hold the FOOTSWITCH assigned to the Delay for

approximately 2 seconds� The LED above the footswitch will begin ﬂashing at the rate of the

currently set delay time�

5� Tap the Delay assigned FOOTSWITCH at the desired rate to adjust the delay time� The LED

above the footswitch will update, ﬂashing at the rate of the new delay time�

6� When done, press and hold the FOOTSWITCH assigned to the Delay for approximately 2

seconds to exit Tap Tempo� The LED above the footswitch will stop ﬂashing�

DigiTech RP360 XP User Manual

Other manuals for DigiTech RP360 XP