53
RP360 / RP360 XP
Factory Restore
This system option is used to restore all RP
presets and system settings back to their factory
default state�
Plexi-Drive 1
LOOPER READY
SYSTEM SETTINGS 4/4
CALIBRATE
PEDAL
FACTORY
RESTORE
FIRMWARE
VERSION
START START
v 1.1.0.0
WARNING! Performing the factory restore procedure will restore all user presets back to their
factory default state� Any changes you have made and stored to user presets will be lost! Once
performed, this procedure is irreversible�
To perform the factory restore procedure:
1�
Press the SYSTEM button�
2� Press either the SELECT knob or SYSTEM button repeatedly until the LCD display reads 4/4 in
the upper right-hand corner of the LCD display�
3� Turn the EDIT 2 (FACTORY RESTORE) knob to initiate the factory restore procedure�
4� Press and hold the SELECT knob to confirm the action� The device will now reset, indicated by
the “Resetting���” prompt in the LCD display� Wait for the factory restore procedure to finish�
5� If using an RP360, the procedure is now complete� If using an RP360XP, you must proceed to
the next step to calibrate the expression pedal�
6� Once complete, you will be prompted to calibrate the expression pedal (RP360XP only)� Follow
the on-screen instructions� See Calibrate Pedal on page 52 for instructions on performing
this calibration procedure�
To Next Page
Loading...
Need help?
General
