DigiTech RP360 XP User Manual

37
RP360 / RP360 XP
Using An Optional FS3X Footswitch
An optional DigiTech FS3X Footswitch can be connected to the RP’s CONTROL IN connector to add
three additional footswitches for RP control� There are two parameters in the System Settings menu
that will determine how these FS3X footswitches will function, they are: the CONTROL IN parameter
and the FOOTSWITCH MODE parameter� These parameters are accessed by pressing the
SYSTEM
button� See Control In on page 49 for further information on changing the CONTROL IN option�
See Footswitch Modes on page 41 for further information on changing the RP’s FOOTSWITCH
MODE�
FS3X Footswitch Functions
The below matrix shows the functions each of the FS3X footswitches will perform depending upon
how you configure the CONTROL IN and FOOTSWITCH MODE parameters�
FOOTSWITCH MODE
SET TO “PRESET”
FOOTSWITCH MODE
SET TO “STOMP”
FOOTSWITCH MODE
SET TO “BANK”
DISPLAY
Plexi-Drive
1
LOOPER READY
REVERB
Plexi-Drive
1
MOD FX DELAY
Plexi-Drive
1
1 2 3
BANK: 1
FS3X
FOOTSWITCH
CONTROL IN
SET TO “FS3X”
Preset
Bypass
Tuner -
*Multi
Loop
Preset
Down
Preset
Up
*Multi
Loop
Bank
Down
Bank
Up
CONTROL IN
SET TO “LOOPER”
*Multi
Loop
Stop
Loop
Clear
Loop
*Multi
Loop
Stop
Loop
Clear
Loop
*Multi
Loop
Stop
Loop
Clear
Loop
*Multi Loop means a single footswitch controls multiple Looper functions. See the diagrams on the following
pages to see each of these Looper functions.

DigiTech RP360 XP Specifications

General

Brand	DigiTech
Model	RP360 XP
Category	Music Pedal
Language	English