9
RP360 / RP360 XP
Stereo Ampliers
Amp 1 Amp 2
Guitar
Harman PS0913DC
Power Supply
Volume/Expression
Pedal (RP360 Only)
Or
Optional
Footswitch
Follow these steps to use the RP with a pair of amplifiers:
1� Turn down the amplifiers’ master volume controls and power off the amps�
2� Make all the connections to the RP as shown in the diagram�
3� Turn the RP on by connecting the included power supply to the POWER input
connector and connecting the other end to an available AC outlet�
4� Turn on your amplifiers� Strum your guitar and gradually increase your amplifiers’
master volume controls until the desired level is achieved�
5� For stereo operation you will need to change the OUTPUT MODE parameter to STEREO� See
Output Mode on page 45 for information on configuring the RP for stereo operation�
To Next Page
Loading...
Need help?
General
