44
RP360 / RP360 XP
Output To
This system parameter has two options: AMP and
MIXER� This parameter optimizes the outputs
for connection to an amp or a mixer and is only
available when a connection has been made to the
LEFT OUT or RIGHT OUT connector�
Plexi-Drive 1
LOOPER READY
SYSTEM SETTINGS 1/4
FOOTSWITCH
MODE
OUTPUT
TO
OUTPUT
MODE
PRESET
STOMP
BANK
AMP
MIXER
MONO
STEREO
• AMP
Select this option when connecting to a guitar amplifier� This is the default option selected
whenever a connection is made to the 1/4” LEFT OUT or RIGHT OUT connector�
• MIXER
Select this option when connecting the 1/4” LEFT OUT/RIGHT OUT connectors directly to a
mixer or recording interface, or when recording through the USB connection� When this option
is selected, the outputs will be optimized for full range speakers, making your guitar’s direct
signal sound as though it’s being played through a guitar speaker cabinet�
NOTE: When no connection is made to the 1/4” LEFT OUT or RIGHT OUT connector, the
MIXER option will automatically be selected behind the scenes, optimizing the outputs for use
with the 1/8” HEADPHONE output or USB output�
To edit the OUTPUT TO option:
1�
Press the SYSTEM button� Ensure you are on the first page in the System Settings menu,
indicated by 1/4 being displayed in the upper right-hand corner of the LCD display� If you are
not, press either the
SELECT knob or SYSTEM button repeatedly until the LCD display reads
1/4�
2� Turn the EDIT 2 (OUTPUT TO) knob to select the desired option�
3� Press the BACK button or any FOOTSWITCH to exit the System Settings menu and return to
the Performance state�
To Next Page
Loading...
Need help?
General
