Dish Network Receiver User Manual

Chapter 3
Page 106
Using the System
Scan for Device Codes
If the code for your device is not listed in the tables starting on page 131, use
this procedure to scan the remote control’s memory for the device code.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
stop here.
Sometimes the blank POWER
button works when other buttons
don’t.
10. If the code doesn’t work, redo
steps 3 through 9 with another
device code from the tables.
Try every code listed for you brand
until one works for your device.
11. For combination devices:
Repeat this procedure from
step 3.
12. If you can’t find a code that
works try Scan for Device
Codes that follows.
1. Turn the device on. Use the device’s front panel buttons
or its remote control.
2. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
3. For AUX mode only.
• Press 0 for a second TV.
• Press 1 for a second VCR
or DVD/BD player.
• Press 2 for a tuner or
audio amplifier.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 4.
4. For AUX mode only: Press
the STAR button.
5. Press the blank POWER
button.
This puts your remote in the scan
mode.

Dish Network Receiver Specifications

General

Brand	Dish Network
Model	Receiver
Category	Receiver
Language	English