Dish Network Receiver User Manual

Chapter 3
Page 116
Using the System
Testing the System
Starting a Test
1. Press the MENU button.
2. Select the System Setup option.
3. Select the Diagnostics option.
Telephone Connection Test
This test checks that the receiver telephone connection is correct. Select the
Connection option to begin the test. The receiver displays a message asking
you to wait until the test is done.
• If the telephone connection is correct, the receiver displays a
Phone
Connection OK message.
• If the receiver highlights the
Done option, select the Dial Out option so the
receiver can make a toll-free call to the Customer Service Center. Press the
remote control SELECT button to start the call. The receiver displays a
message asking you to wait until the call is done. When the call is done,
select the
Done option to exit the test menu.
• If the telephone line is not connected properly, the receiver displays a
failure message. In this case, check the telephone connection and then
repeat the test.
Note: If you have the receiver connected to a DSL (Digital Subscriber Line)
phone line, it may cause this test to fail. If so, you will need to install a DSL
filter between the satellite receiver and the telephone jack on the wall. You
should be able to get a DSL filter from your DSL provider, or your local
consumer-electronic parts store.

Dish Network Receiver Specifications

General

Brand	Dish Network
Model	Receiver
Category	Receiver
Language	English