15.1 Tests
WARNING
Infection due to contaminated unit
❯
Clean and disinfect the suction before
working on the unit.
❯
Wear protective equipment when
working (e. g. impermeable gloves,
protective goggles and mouth and
nose protection).
In some countries the owner is required
to keep an operating handbook. This
operating handbook must document all
maintenance work, service work, checks
and amalgam disposal.
Annual inspection
This inspection should only be carried out by
suitably trained staff.
Work steps to be performed:
❯
General functional check (e.g. aspiration,
spittoon inlet)
❯
During the sediment fill level measurement,
visually inspect the operability of the sedi-
ment sensor.
❯
Service program
Inspection of the general operating condition
every 5 years
This inspection must be carried out every 5 years
(in accordance with the German Waste Water
Regulations, Annex 50, Dental Treatment) by an
inspector in accordance with national regulations.
For inspection, the following are required:
ü
Empty collecting container
ü
Measuring beaker
Work steps to be performed:
❯
Fill the collecting container with water (min.
900 ml) and insert it into the unit.
❯
Start the device and wait until it switches off
again.
❯
Once the device has switched off, remove
the collector vessel and measure the remain-
ing amount of water.
The unit is working correctly if:
– There is at least 610 ml left in the amalgam
collecting container.
If there is less fluid, clean the centrifuge drum or
check the operation of the unit.
Usage
34 9000-606-44/30 2011V003
EN
To Next Page
Loading...
Need help?
General
