Maintenance Manual (960-946) 4-26
Replacement Procedures
Figure 4-28 Removing the 3G antennas (1)
4. Peel off the 3G antennas from the Cover Assembly.
Figure 4-29 Removing the 3G antennas (2)
4.22.2 Installing the 3G antennas
To install the 3G antennas, follow the steps below and refer to Figure 4-28
to Figure 4-29.
1. Stick new 3G antennas (AUX/Main) in place.
2. Arrange the 3G antenna cables and SAR harness in place on the
Cover Assembly, and fix them with the stick stapes.
3. Stick one piece of INSU on the 3G antenna (Aux).
4. Connect the SAR harness to the connector CN2650 on the USB board
(FMERLT*).
3G antenna (Main)
3G antenna (Aux)
Do not reuse the removed 3G antennas. Be sure to use new 3G antenna.
To Next Page
Loading...
Need help?
General