E-one Extreme Series User Manual

34
3. Slide the EQD housing down the Power Cable.
4. Remove the wires from the EQD insert by loosening the six retaining screws.
Figure 7-3
EQD Reassembly
1. Slide the EQD housing (with cable fitting installed and compression nut loose) over the
power cable.
2. If you are changing the Tray Cable side, then install the water tight grommet onto the wires.
Be sure to keep the tapered side toward the cable jacket, not the cable end.
Figure 7 - 4
Taper

E-one Extreme Series Specifications

General

Brand	E-one
Model	Extreme Series
Category	Water Pump
Language	English