E-one Extreme Series User Manual

52
8. Grasp the wires of the Transponder Board and gently pull to remove it.
Figure 9 – 8
Level Sensor Reassembly
1. Install the Transponder Board, with the tab oriented up and toward the top of the Level
Sensor, into the slots in the On/Off side and secure it with the Philips head screw and
retaining washer.
2. If the barbed fitting is being replaced, put a fine bead of Loctite 598 on the threads
before installing them into the assembly.
Figure 9 – 9

E-one Extreme Series Specifications

General

Brand	E-one
Model	Extreme Series
Category	Water Pump
Language	English