Eaton Tandem ELF Current-Limiting Dropout Fuse Installation, Operation And Maintenance Instructions

Replacing the control
To place a control into the control enclosure, follow the
procedure outlined below:
1. Engage control on enclosure hinges.
2. Connect control ground lead to back panel.
3. Reconnect control to back panel at TB2, located at the
bottom of back panel.
4. Push closed disconnect switch V1 (and V6 if present).
5. Pull open current shorting switch C.
6. Close control and tighten locking screws.
17
CL-6 SERIES CONTROL INSTALLATION, OPERATION, AND MAINTENANCE INSTRUCTIONS MN225016EN January 2016

Eaton Tandem ELF Current-Limiting Dropout Fuse Specifications

General

Brand	Eaton
Model	Tandem ELF Current-Limiting Dropout Fuse
Category	Cables and connectors
Language	English