1 Planning
1.1 About this document
This manual provides information on planning, mounting, wiring, and initial setup
of the Micro Motion transmitter. For information on full configuration, maintenance,
troubleshooting, or service of the transmitter, see the Micro Motion 4200 Transmitters
Configuration and Use Manual.
The information in this document assumes that users understand basic transmitter and
sensor installation, configuration, and maintenance concepts and procedures.
1.2 Hazard messages
This document uses the following criteria for hazard messages based on ANSI standards
Z535.6-2011 (R2017).
DANGER
Serious injury or death will occur if a hazardous situation is not avoided.
WARNING
Serious injury or death could occur if a hazardous situation is not avoided.
CAUTION
Minor or moderate injury will or could occur if a hazardous situation is not avoided.
NOTICE
Data loss, property damage, hardware damage, or software damage can occur if a
situation is not avoided. There is no credible risk of physical injury.
Physical access
WARNING
Unauthorized personnel can potentially cause significant damage and/or
misconfiguration of end users' equipment. Protect against all intentional or unintentional
unauthorized use.
Physical security is an important part of any security program and fundamental to
protecting your system. Restrict physical access to protect users' assets. This is true for all
systems used within the facility.
1.3
Related documentation
See the approval documentation shipped with the transmitter, or download
the appropriate documentation from the Micro Motion web site ( Emerson.com/
flowmeasurement):
• Micro Motion 4200 Transmitters Configuration and Use Manual
• Micro Motion 4200 2-Wire Transmitter Product Data Sheet
• Micro Motion 4200 2-Wire Safety Manual for Safety Instrumented Systems (SIS)
Installation Manual Planning
MMI-20058013 March2024
Installation Manual 5
To Next Page
Loading...
Need help?
General
