Emerson Tescom ER5000 Series User Manual

ER5000 —
87
Installation Variations
Setpoint Wiring Variations
Profile with External Control/Digital Inputs
NOTENOTE
CAUTIONCAUTION
WARNINGWARNING
This feature is only available on “F” models of the ER5000.
NOTENOTE
CAUTIONCAUTION
WARNINGWARNING
Jumpers J14 and J15 must be removed for this application. Refer
to Figure 19.
Figure 26 shows the wiring conguration for controlling a Prole
without using a PC. The Prole that has been downloaded into
the ER5000 in this application can be started or stopped with a
toggle switch.
WHITE
ORANGE/BLACK
PROFILE
START/STOP
DIGITAL
INPUT
BROWN/WHITE
RED/BLACK
YELLOW/BLACK
BLACK/WHITE
Figure 26: External Profile Control
WARNING
The controller must be disconnected from the power supply before
any additional wiring or change to jumper configuration is
performed. Do not reconnect the power supply until all additional
wiring connections have been made and are properly installed.
Refer to Table 9 to verify correct wiring.
Table 9: Wiring for Profile Control Using Auxiliary Inputs
J3 Pins Wire Color Function
1 brown +setpoint input
2 red -setpoint input
3 orange +feedback input
4 yellow -feedback input
5 green -RS485 network connection
6 blue +RS485 network connection
7 violet +24V DC power
8 gray 24V return (power ground)
9 white +5V output (5 mA max.)
10 black analog signal/board ground
*11 *pink analog signal output
(active in Enhanced “F” models ONLY)
12 tan analog signal/board ground
J4 Pins Wire Color Function
1 brown/white +aux input #1
2 red/black -aux input #1
3 orange/black +aux input #2
4 yellow/black -aux input #2
5 green/white suspend control
6 black/white digital output/board ground
7 blue/white digital output #1
8 gray/black digital output #2
(continued next page)

Emerson Tescom ER5000 Series Specifications

General

Brand	Emerson
Model	Tescom ER5000 Series
Category	Controller
Language	English