Emerson Vilter VSS User Manual

5 – 55
Section 5 • Maintenance/Service
VSS/VSM/VSH/VSSH • Installation, Operation and Maintenance Manual • Emerson • 35391SD
Compressor Shaft Seal Replacement
Shaft Seal Assembly
The shaft seal is made up of a mating ring and a carbon
or silicon carbide (SC) component.
The mating ring is the rotating part of the seal and is in-
stalled against the shaft shoulder. It has a drive notch on
one end which aligns with the drive pin inserted in the
shaft.
Figure 5-58. Shaft Seal Assembly
Figure 5-59. Handling Seal Face with Care
Carbon or SC component is the stationary part of the
seal and is installed into the shaft seal housing using an
O-ring.
The shaft seal housing with the stationary part is assem-
bled in the compressor main housing using an O-ring,
see Figure 5-58.
The shaft seal needs to be carefully handled and
installed to function properly. Please see Figure 5-59 for
details.
Handling Seal Face with Care
• Avoid touching seal faces as much as
possible during installation.
• Be sure to always keep seal faces
face-up, rather than face-down, see
image on the right.

Emerson Vilter VSS Specifications

General

Brand	Emerson
Model	Vilter VSS
Category	Air Compressor
Language	English