Emerson Vilter VSS User Manual

5 – 10
Section 5 • Maintenance/Service
VSS/VSM/VSH/VSSH • Installation, Operation and Maintenance Manual • Emerson • 35391SD
Oil Sample Analysis Report
NOTE
A copy of the oil analysis report is also sent to Vilter. See
Appendices for a sample of the oil analysis report.
An oil analysis report will show the physical properties of
the oil, such as:
• Water content
• Viscosity
• Acid number
• Particle count
• Antioxidant level
• Wear metals
• Contaminating/additive metals
3. In most cases there will be foam in the oil, so you
must ll the bottle up to the top and then wait for
the foam to dissipate. Repeat this step as many times
as necessary (around 4 to 6 times) until the clear oil
level reaches ¾ full, see sequence in Figure 5-6.
4. After all the foam dissipates, tighten the sample
bottle cap.
5. Tighten the oil sampling valve cap.
6. For valve #3709A only: back seat the knurled lock-
nut by turning it counter-clockwise. This is to pre-
vent any accidental release, see Figure 5-4 (c).
7. Attach the lled sampling information label to the
bottle and mail the sample out to the oil analysis lab
immediately.
NOTE
Missing information from the sampling label may result
in longer turnaround time as the laboratory will need to
request the info before the sample can be tested.
Figure 5-6. Stages of the Oil Sample Taking Process

Emerson Vilter VSS Specifications

General

Brand	Emerson
Model	Vilter VSS
Category	Air Compressor
Language	English