Sigma DS4 and DS4-ES1 Instant Financial Issuance System 77
153: Insert same card side 2 up
1. Take the card from the printer and turn it over end to end so side 2 is facing up.
2. Insert the card in the printer.
3. If the card is not immediately picked, press the printer’s U
SER button.
170: Insert new card side 1 up
1. Insert a new card in the printer with side 1 facing up.
2. If the card is not immediately picked, press the printer’s U
SER button.
171: Insert same card side 1 up
1. Take the card from the printer and turn it over end to end so side 1 is facing up.
2. Insert the card in the printer.
3. If the card is not immediately picked, press the printer’s U
SER button.
172: Insert cleaning card
1. Insert cleaning card.
2. If the card is not immediately picked, press the printer’s U
SER button.
173: Improper shutdown
Always use the power button to power off the printer.
Press and hold the U
SER button to set the printer to Ready.
245: Configuration error
The configuration is not compatible with the printer model. The printer cannot print cards until
the configuration issue is corrected. Contact your service provider for assistance.
275: Multi-hopper error
The multi-hopper has encountered a critical error. The card will be canceled.
1. Press the printer P
OWER button to power off the printer.
2. Press the P
OWER button again to power on the printer.
If the error occurs again, request service.
Click OK in the Card Printer Driver message to clear the message.
To Next Page
Loading...
Need help?
General
