Epilog Laser Fusion Pro 48 User Manual

- 13 -
SECTION 2: GETTING STARTED
Setting up your Epilog Laser System is easy to do! If you’ve ever installed a paper printer, this is only slightly
more diicult. The following information will help you understand the entire system and how it works.
Your Fusion Pro laser system consists of the following components:
1. Fusion Pro Laser System
2. Epilog USB thumb drive with Soware Suite installation files
3. USB and Ethernet Cables
You will also need:
1. A computer or laptop.
2. An exhaust fan: The exhaust fan is mandatory and is used to remove smoke and debris from the
Fusion Pro work area. The exhaust air can be ported to the outside or into a filter box.
Follow these steps to set up your Fusion Pro Laser system:
1. Unpack the laser system.
2. Choose where to locate the system.
3. Connect the exhaust system to your laser.
4. Connect the electrical power.
5. Connect the laser to your computer through USB or Ethernet connection.
6. Sign up for driver updates and register your system at www.epiloglaser.com/register.

Epilog Laser Fusion Pro 48 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 48
Category	Engraver
Language	English