Epilog Laser Fusion Pro 48 User Manual

Setting Up Adobe Illustrator for the Laser
If you are using Adobe Illustrator, you will need to use the following settings when printing to the Soware
Suite.
1. In Illustrator click File > Print when you’re ready to send your artwork to the Soware Suite.
2. In the print settings, under Printer select “Epilog Engraver”, then set the Media Size to “Custom” .
Doing this will automatically feed the correct page size to the Epilog Engraver driver. Then click
“Print” to send your job to the Epilog Soware Suite.
- 61 -
SECTION 5: THE LASER DASHBOARD

Epilog Laser Fusion Pro 48 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 48
Category	Engraver
Language	English