Epilog Laser Fusion Pro 48 User Manual

Compatibility
Your Epilog Laser has been designed as an “open architecture” product that can be run from almost any
Windows based soware.
Recommended PC
For Optimum Computer Peormance
Investing in a new computer is a great way to make sure you’re getting the most out of your new laser
equipment. Why? Because today’s soware (CorelDraw for instance) requires a lot of computer processing
speed and memory to function properly. A good computer won’t make a big dierence in how your
laser runs, but when compared to a slow computer it will save untold amounts of time and frustration
setting up the artwork that you “print” to the laser. Many users do not purchase new computers for use
with their new laser because their current computers are peectly adequate. There’s no magical cut-o
that makes a computer too slow. If you’re comfortable with the peormance and speed of your current
computer, there’s probably no reason to purchase another one. The following recommendations are just
advice to consider if a new computer is necessary.
A new computer doesn’t have to be expensive to work great. The minimum requirements are included in
just about any new laptop or desktop that can be purchased.
Operating System
Windows 7, Windows 8.1, or Windows 10 will work with the Fusion Pro and the Epilog Soware Suite.
Operating system should have all system updates before installation of the Epilog Soware Suite.
RAM – Random Access Memory
4GB RAM is the minimum that is required, however we recommend 8GB or more if possible. RAM is like
short-term memory. It’s fast and readily available for the computer to access and makes time consuming
tasks go much quicker if you have lots of it. Having more than 4GB of RAM is nice if you demand a lot from
your computer.
Processor Speed
A faster processor will allow you to do more tasks in less time. While it’s not necessary to purchase the
fastest processor available, you’ll want adequate speed to operate your graphics program. Processor
speeds are always improving, but processor speeds of about 3.0 GHz or faster are a good place to start.
Graphics Card
Your computer’s graphics card will need to support OpenGL 3.0 (or higher) or OpenGL 2.0ES (or higher) to
operate the Epilog Soware Suite. For example, an Intel HD 2000 or greater, nVidia GeForce 8000 series or
greater, or an AMD/ATI Radeon HD2000 series or greater will be suicient.
10/100 Network Inteace Card (NIC)
All new computers have a 10/100 network connection as standard equipment. As well as allowing
multiple computers to be linked together in a network, this technology also allows direct printing from
the computer to the laser. Epilog supplies a network Crossover cable with each laser system that allows
one computer to print to a single Epilog Laser system.
Hard Drive
This is the permanent memory in your computer. Many users feel that you can never have a large enough
hard drive. Luckily, most computer manufacturers put high capacity drives in new computers these days.
- 198 -
SECTION 13: SPECIFICATIONS

Epilog Laser Fusion Pro 48 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 48
Category	Engraver
Language	English