Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status of the projector. Items that can be displayed vary depending on the Source
currently being projected as shown in the following screen shots.
Computer/HDMI
*
S-Video/Video USB Display/USB
*
* EB-W10/X10 only
Sub Menu Function
Lamp Hours
You can display the cumulative Lamp operating time
*1
.
When it reaches the lamp warning time, the characters are displayed in yellow.
Source
You can display the Source name for the connected equipment currently being projected.
Input Signal
You can display the content of Input Signal set in the Signal menu according to the Source.
Resolution
You can display the input resolution.
Video Signal
You can display the content of Video Signal set in the Signal menu.
Refresh Rate
g
You can display the Refresh Rate.
Sync Info
You can display the image signal information.
This information may be needed if service is required.
Status
This is information about errors that have occurred on the projector.
This information may be needed if service is required.
*1 The cumulative use time is displayed as "0H" for the first 10 hours. 10 hours and above is displayed as "10H", "11H", and so on.
List of Functions
55
To Next Page
Loading...
Need help?
General
