Other problems
No sound can be heard or the sound is faint
Check Remedy
Is the audio source connected correctly? Disconnect the cable from the Audio port, and then reconnect the cable.
Is the volume adjusted to the minimum setting? Adjust the volume so that sound can be heard. s p.52 s Quick Start Guide
Is A/V Mute active? Press the [A/V Mute] button on the Remote Control to cancel A/V Mute. s p.25
Is the audio cable's specification "No resistance"? When using a commercially available audio cable, make sure it is labeled "No resistance".
The Remote Control does not work
Check Remedy
Is the Remote Control light-emitting area pointing towards the
Remote Receiver on the projector when it is operated?
Point the remote control towards the Remote Receiver.
Operating range s Quick Start Guide
Is the remote control too far from the projector? The operating range for the remote control is about 6 m. s Quick Start Guide
Is direct sunlight or strong light from fluorescent lamps shining onto
the Remote Receiver?
Set the projector up in a location where strong light does not shine onto the Remote Receiver.
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s p.74
I want to change the language for messages and menus
Check Remedy
Change the Language setting. Adjust the "Language" setting from the Configuration Menu. s p.53
Problem Solving
69
To Next Page
Loading...
Need help?
General
