Epson EH-TW5910 User Manual

Useful Functions
57
Switching the image source
You can switch the image source for the AV device connected to the WirelessHD Transmitter. When switching,
each input source is displayed on one screen as a preview. This allows you to switch easily between image
sources even when two or more devices are connected using HDMI.
The projector uses Insta Prevue Technology from Silicon Image, Inc.
Switching the source
a
Point the remote control at the
WirelessHD Transmitter, and then
press the
button.
Remote control WirelessHD Trans-
mitter
Displays the sub-screen for the connected
device.
b
The target screen changes each time
you press the
button.
c
After selecting the target screen,
please wait for a moment.
The projected image is switched.
Displaying as a sub-screen
a
Point the remote control at the
WirelessHD Transmitter, and then
press the
button.
Displays the sub-screen for the connected
device.
b
When switching between the sub-
screen and the main screen, hold
down the
button (for
approximately 3 seconds) until the
screen changes.
c
To close the sub-screen, press the
button again.
The projected image is switched.

Epson EH-TW5910 Specifications

Image

color light output	2, 100 lumen
white light output	2, 100 lumen
resolution	1920 x 1080
contrast ratio	20, 000:1

Optical

projection ratio	1.32 - 2.15:1
projection size	30 inches - 300 inches
projection distance wide	0.9 m - 8.9 m
projection distance tele	1.4 m - 14.5 m

Power

energy use	358 W
economy energy use	274 W
standby energy use	0.35 W

Connectivity

interfaces	RS-232C, VGA in, HDMI 1.4 (2x), Composite in, USB 2.0 Type A, USB 2.0 Type B, Component in
loudspeaker	20 W
stereo	Stereo

Weight and Dimensions

product dimensions	420 x 365 x 137 mm
product weight	6 kg
noise level economy	24 dB (A)