Epson EH-TW5910 User Manual

Troubleshooting
77
Problem Solving
Reading the Indicators
You can check the status of the projector from the flashing and lit , (operation indicators), o and m
on the control panel.
Refer to the following table to check the projector's status and how to remedy problems shown by the
indicators.
Indicator status during an error/warning
: Lit : Flashing : Off
Indicators Status Remedy
(orange)
Replace Lamp
It is time to replace your lamp. Replace the lamp with a new lamp
as soon as possible.
s p.92
The lamp may explode if you continue to use it in this status.
(orange)
High Temp Warning
You can continue projecting. If the temperature rises too high
again, projection stops automatically.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s p.88
(red)
Internal Error
The projector has malfunctioned.
Remove the power plug from the electrical outlet, and contact
your local dealer or the nearest Epson repair center.
s Epson
Projector Contact List
(red)
Fan Error
Sensor Error

Epson EH-TW5910 Specifications

Image

color light output	2, 100 lumen
white light output	2, 100 lumen
resolution	1920 x 1080
contrast ratio	20, 000:1

Optical

projection ratio	1.32 - 2.15:1
projection size	30 inches - 300 inches
projection distance wide	0.9 m - 8.9 m
projection distance tele	1.4 m - 14.5 m

Power

energy use	358 W
economy energy use	274 W
standby energy use	0.35 W

Connectivity

interfaces	RS-232C, VGA in, HDMI 1.4 (2x), Composite in, USB 2.0 Type A, USB 2.0 Type B, Component in
loudspeaker	20 W
stereo	Stereo

Weight and Dimensions

product dimensions	420 x 365 x 137 mm
product weight	6 kg
noise level economy	24 dB (A)