To Next Page

To Previous Page

5. Select the SSID for the access point from printer's control panel, and then press the OK button.

Note:

❏ If the SSID you want to connect to is not displayed on the printer's control panel, select Search Again to update the

list. If it is still not displayed, select Other SSIDs, and then enter the SSID directly.

❏ If you do not know the SSID, check if it is written on the label of the access point. If you are using the access point

with its default settings, use the SSID written on the label.

6. Enter the password, and then press the OK button.

Select whether or not you print a network connection report aer nishing the settings.

Note:

❏ e password is case-sensitive.

❏ If you do not know the password, check if it is written on the label of the access point. If you are using the access point

with its default settings, use the password written on the label. e password may also be called a "Key", a

"Passphrase", and so on.

❏ If you do not know the password for the access point, see the documentation provided with the access point, or

contact the person who set it up.

❏ If you fail to connect, load paper, and then press the

button to print a network connection report.

Related Information

“Entering Characters” on page 17

“Checking the Network Connection Status” on page 26

“When You Cannot Make Network Settings” on page 120

Making Wi-Fi Settings by Push Button Setup

You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions

are met, you can set up by using this method.

❏

e

access point is compatible with WPS (Wi-Fi Protected Setup).

❏ e current Wi-Fi connection was established by pressing a button on the access point.

Note:

If you cannot nd the button or you are setting up using the soware, see the documentation provided with the access point.

1. Select Wi -Fi S e tu p on the home screen, and then press the OK button.

2. Select Wi-Fi (Recommended), and then press the OK button.

3. Press the OK button.

4. Select Push Button Setup (WPS), and then press the OK button.

User's Guide

Network Settings

Epson L485 SERIES User Manual

Questions and Answers: