8
ONYX rip Settings
There is a number of software for ONYX rip, including RIP Queue, Media Manager, and Job Editor.
This section explains how to configure RIP Queue (Ver. 12).
Install and Connect
Install the software to your computer in the following order.
(1) Communication driver of the printer you use
(2) Dashboard
(3) ONYX rip
(4) ONYX rip printer driver (.PrnInst)
(5) Epson exclusive wide gamut input profile file (Installed together with Dashboard)
Important :
・(1) Install the communication driver from the software disk that came with your printer or from Setup Navi
(http://epson.sn/
). If the following screen appears during installation, make sure to click [Install].
・(4) When the ONYX rip printer driver (.PrnInst) is installed, the following screen will appear.
Copy and paste or type the serial number of the printer displayed on the [Home] screen of Dashboard.
Once all of the installations are completed, connect the RIP and Dashboard with the following steps.
To Next Page
Loading...
Need help?
General