9
3. Instructions for Use
3.1 Installation
(1) Do not expose the device to sunlight or bright light from lighting
equipments.
Do not install the device in places where either dust or rubbish may
accumulate.
Also, the environments with extremes in heat and
humidity should be avoided.
In case of using the device, ensure to comply with the
environmental conditions of unpacking and usage before
starting a measurement.
・Temperature range for use: 5 to 40
・Humidity range for use: 30%HR to 95%HR
・Temperature range for storage: -10 to 55 (No dew condensation)
・Humidity range for storage: 10%HR to 95%HR (No dew condensation)
(2) Keep away from inflammable or explosive gases as
well as storage area of the medical supplies and
chemicals.
(3) Keep away from the sites that experience strong
vibrations or sudden shocks.
(4) The device might be broken if it falls down. Also,
it might cause injury if dropping it. Therefore, do
not store it at an unstable place or in high, ‘out of
reach’ place.
(5) Keep this device away from water (liquid).
・Degree of protection: IP20
Dust
Gas
Take extra caution to avoid strong light because
it may cause the failure of measurement.
NOTE
To Next Page
Loading...
Need help?
General
